The University of Queensland
School of Engineering

ENGG1010 Applied Mechanics

DYNAMICS

Please check the Blackboard site for all notices and discussion fora relating to ENGG1010.

Laboratory Practicals:

There are two Dynamics practicals (D1 and D2). They are conducted in the ENGG1010 Dynamics laboratory, located in room 45-207 on level 2 of the Mansergh-Shaw Mechanical Engineering Building. Go to the Blackboard site for details of the laboratory schedule.

**** Student Safety Declaration Form for Mansergh-Shaw Building **** This form will need to be completed and signed by all students at their first laboratory session.

Dynamics Online Tutorials

The Dynamics Online Tutorials are offered through an interactive quiz site.

The Dynamics Tutorials do not count to your ENGG1010 final mark but are an important learning tool that will assist you to learn the material in the course and give you feedback on how you are progressing.

If you believe the tutorial question (or the answer) is wrong, please raise the point at the ENGG1010 Blackboard Dynamics Discussion Board (only for UQ students enrolled in the course).

List of Tutors for Semester 2010/2

Problem Sessions (C1, C2, C3, C4)

Dr Kamel Hooman

Ms Hadas Porat

 
  • Attend the tutorial sessions C1, C2, C3 and C4
  • Guide the students towards solutions without providing them with ready-made templates
  • Encourage and motivate the students to think the solutions themselves instead of seeking for the correct formula
  • Note the common questions each week and e-mail the note to the Dynamics lecturer

Senior Tutor - Lab Pracs (D1 and D2)

Andrew Ridings
  • Before each Dynamics Prac
    • Print out a list of the students scheduled to attend this Prac
    • Examine the Dynamics Laboratory
    • There should be sufficient supply of hand-outs in the cupboard
    • The area is clean
    • Give the Tutor the key to the cupboard and the material necessary for the Prac
    • Give the Tutor the list of students attending this session
  • After each Dynamic Prac
    • Collect the key at the end of the Prac and examine the laboratory again
    • Make sure the cupboard is locked with the Prac material inside
    • Note any Safety Hazards and Risks encountered during the Prac and report them to the Dynamics lecturer
    • Mark the list of attendance on Blackboard after each session
    • If there are any repairs required to the equipment, contact Mr. Doug Malcolm
  • Tutor the designated pracs

Tutors - Tutorial Sessions (T1, T2, T3, T4)
  • Attend the designated tutorial sessions T1, T2, T3 and T4
  • Guide the students towards solutions without providing them with ready-made templates
  • Encourage and motivate the students to think the solutions themselves instead of seeking for the correct formula

Tutors - Lab Pracs (M1 and M2)

 
  • Meet the Senior Tutor (Lab pracs) at the start time of the Tutorial in the Laboratory
  • From the Senior Tutor
    • collect the cupboard key and the prac material
    • collect the list of students scheduled to attend this Prac session
  • Carry out the Prac as per the instructions in the Prac notes (Prac 1
    •  and Prac 2)
  • At the end of the Prac, put things in order (the engines and the benchtops)
  • Put the material back into the cupboard and return the key to the Senior Tutor
  • Give the List of Attendance to the Senior Tutor
  • Note any Safety Hazards and Risks encountered during the Prac and report them to the Senior Tutor